Altera_Forum
Honored Contributor
Honored ContributorSchematic highs and lows
Are there any simple ways to force a schematic signal to logic HIGH other than tying it to VCC symbol? How about forcing a logic LOW other than tying to a GND symbol?
Forum Discussion
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- Are there any simple ways to force a schematic signal to logic HIGH other than tying it to VCC symbol? How about forcing a logic LOW other than tying to a GND symbol? --- Quote End --- The you mentioned above is the simplest way. Also, you can define a middle signal which is connected to VCC or GND, then you can use this middle signal as the high or low.
