Forum Discussion
FrankOuO
New Contributor
New ContributorThe result of Clock divider's Waveform simulation doesn't work properly with top module
Hello, everyone
I just wrote a very simple clock divider by 2,
and I want to add this module: clock_out.v to my top module named light.v
(from the tutorial: Using_the_SDRAM)
But if I running ...
FrankOuONew Contributor
New ContributorSorry for the late reply.
I've found out the reason why the output clock went wrongly.
I didn't assign a specific pin to the output clock so that their was no output signal.
With pin assignment, the waveform simulation and on-board test goes well.
Thank you! @RichardTanSY_Altera
Best Regards,
Frank Lee
