Forum Discussion
SDe_J
Occasional Contributor
Occasional ContributorQuartus 18.1 and 19.1 unable to program stratix 10 L-tile
I think this is a bug, but I'm not sure where to post bug reports. I have been unable to program my stratix 10 L-tile dev kit (1SG280LU2F50E2VGS3) with either quartus pro 18.1 or 19.1. I can progra...
JohnT_Altera
Regular Contributor
Regular ContributorHi,
Please also refer to the exiting issue in Quartus 18.1 or later (https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/component/2019/error---device-has-stopped-receiving-configuration-data-error-me.html). If you design is using the 3V IO then you will need to follow the guideline.
