Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

OpenCL on FPGA Not able to generate hardware for matrix_mult.cl

Hello everyone, I am trying to compile a very basic matrx_mult kernel (also same error occurs for hello_world) for a nallatech 385a board. However, always I am getting the following error: ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

--- Quote Start ---

However, the compilation crash still persists even after a clean installation. Is there any possibility to be a licensing issue even without getting a licence related error ?

--- Quote End ---

I don't think so. Without a valid license, you will not even get past the initial OpenCL to HDL conversion step, let alone fitting and routing.