Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

"Node is missing source" error when working with busses

Hello again, Working on another project for my ECE class. This one is a "tallyer." I've put the schematic below. Basically, I am just wondering: for the bus line that runs from after the r...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

I agree with the suggestion. If you want to use schematic entry however, the signal names should be consistent, address[x] at both sides of the bus...