Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

No output in simulation for Division implemented using IP Core

hello everyone, I have design the division module with the help of lpm_divide. I am using Quartus Prime Lite Edition. I have done simulation on ModelSim Altera Starter Edition. i am getting only Hig...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
10 years ago

--- Quote Start ---

Could you provide more detailed information: have you forced any values, cause modeling start with 'U' value in simualtion, you don't have 'z' i assume.

--- Quote End ---

If it is Verilog, then the value may be 'Z' as there is no 'U'