Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Need to feed two buses with one output

Hello everybody, In my top level design in Quartus I am trying to feed the LSB of two buses with a signal which comes out of a block, usually I do this by naming the output signal the same na...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

Hello Pletz,

Thanks for your answer !

I am using Schematics, in Verilog this is pretty easy actually, turns out

this is also pretty easy in schematics. I need to feed the signal into

2 wire buffers, on the other side of these buffers I can feed two inputs

in the top level. See the Snagit picture I have attached below.

Again, thanks for your answer !!

Cheers,

Eric