MAX 10 Development Kit EtherCAT and ADC

Question

Hi!
I am interested on the MAX 10 FPGA products, specifically on the MAX 10 FPGA Development Kit and MAX 10 FPGA Evaluation Kit.
Regarding the Development Kit one, can the Ethernet ports be used for EtherCAT communication (of course getting the corresponding IP core from Beckhoff)?
Regarding the two kits, for analog-to-digital conversion (ADC), is it necessary to buy/get an ADC IP core, or does it come built-in when buying the kits?
Regarding the software, can be Quartus Pro used for both kits? And, can code be reused from one board to another (of course assigning the right pins)?I hope you can solve my questions. Thank you!Best regards,Miguel Garnelo

ar_a_intel · Answer

Hello

Welcome to INTEL forum. May we know, is this the board that you’re referring to?

https://www.intel.com/content/www/us/en/programmable/products/boards_and_kits/dev-kits/altera/max-10-fpga-development-kit.html

miguelgarnelo · Answer

Hello,

Thanks for your answer!
Yes, that's the board I am interested in using.

ar_a_intel · Answer

Hi

Thanks for update. Based on my understanding, you need to buy the IP core. Kindly contact your nearest Intel salesperson or distributor.

https://www.intel.com/content/www/us/en/partner/where-to-buy/overview.html

And yes. The Ethernet ports be used for EtherCAT communication.

MAX 10 FPGA is not available in Quartus Pro. Refer to https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/po/ss-quartus-comparison.pdf For software, it is advice to use Quartus version 15 and above.

Regarding “can code be reused” Could you elaborate more what do you means?

miguelgarnelo · Answer

Hi

Thanks again for your reply! Regarding the IP core you mention to buy is the one for ADC or the one from Beckhoff to use EtherCAT over an FPGA?

Regarding reusing the code, I was meaning using the code developed with the MAX 10 development board discussed in this thread in a self-designed board including a MAX 10 FPGA.

Thank you!

ar_a_intel · Answer

Hi The IP is regarding on ADC and based on my understanding, yes you can reuse the code developed with the MAX 10.

Forum Discussion

MAX 10 Development Kit EtherCAT and ADC

8 Replies

Recent Discussions

My signaltap test has some problem

Questa-ModelSim UI scaling problems in Linux

USB Blaster III and Cyclone III

Serial Lite IV - Rx Simulation Issues

USB-Blaster II malfunction