Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Load a .pof in flash using PFL in command line

Hello, I'd like to program my flash using a .pof file and the parallel flash loader as described here in the application note : AN478 This is working, and I'd like to do the same in command ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

I meant the pin on the Flash memory device. In my case this pin was controlled by the PFL and laso a microprocessor that used the Flash as its program memory after the PFL configured the FPGA.