Forum Discussion

MBell6's avatar
MBell6
Icon for New Contributor rankNew Contributor
7 years ago

How to properly connect signals in schematic project for QUARTUS II

Hi, I'm forced to use schematic approach for a project (instead of VHDL). My problem is the following: I have two buses, for istance BUS_A[3..0] and BUS_B[2..0], I would like to connect BUS_A[3] s...
Vicky1's avatar
Vicky1
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi,

In this case, bus need to be split like (BUS_A[3..1],BUS_A[0]) or (BUS_A[3],BUS_A[2],BUS_A[1],BUS_A[0])

Refer the below old thread & screenshot for your reference,

https://forums.intel.com/s/question/0D50P00003yyG8bSAE/how-to-extract-1bit-from-a-bus-in-a-block-diagramschematic-file

please provide screenshot of your bdf file for better support.

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

Best Regards

Vikas Jathar

(This message was posted on behalf of Intel Corporation)