Forum Discussion

MohdAnnuar_S_Intel's avatar
MohdAnnuar_S_Intel
Icon for New Contributor rankNew Contributor
7 years ago

How to debug jtagconfig not detecting JTAG hardware?

This is seen on quartus prime pro Linux version 16.0.0.211 installed on SLES 11 with udev rules as below: ATTR{idVendor}=="09fb", ATTR{idProduct}=="6810", ACTION=="add", RUN+="/bin/sh -c 'chmod 666 ...
YuanLi_S_Intel's avatar
YuanLi_S_Intel
Icon for Regular Contributor rankRegular Contributor
7 years ago

Hi Annuar,

If you have followed the steps to setup in Linux, by right it shouldn't have any problem.

Please help me to understand the scenario so that i can help you:

  1. May i know, is your system detected the USB Blaster when it is connected to your system?
  2. If it is detected but you cannot find the JTAG using "jtagconfig -n" command, can you launch quartus programmer and setup as shown at link below?https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug-intel-fpga-download-cable-ii.pdf (Page 7)
  3. May i know are you using custom board or intel PSG development kit?

Regards,

YL