Forum Discussion

JWrig25's avatar
JWrig25
Icon for Occasional Contributor rankOccasional Contributor
6 years ago

Having issues getting Quartus Prime Standard Edition 18.1 to recognize my Stratix V GX FPGA board. Whenever I go to the hardware setup, there is no hardware listed and when I go to add new hardware the Auto Detect doesn't work, any ideas?

The board is powered and switched ON when I try to locate the hardware on Quartus, it is connected to my laptop via an Ethernet cable so I thought the EthernetBlaster would auto detect my board but i...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
6 years ago

That ethernet is for an ethernet connection to a design already programmed into the device, not for device programming. Like you say, you need a USB cable to program the device.

#iwork4intel

  • JWrig25's avatar
    JWrig25
    Icon for Occasional Contributor rankOccasional Contributor
    6 years ago

    Do you know what specific type of USB I need?