Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Gate level Simulation passes but design fails on target borad

Hello, I am implementing a filter (2nd order) in Quartus Stratix II device running at 500KHz. I simulated the design using ModelSim. My Target hardware consists of stratix II device. Input...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Agreed to ur point.

I now, can generate freq from signal generator in the board set up.

In this case I have control over the freq of the input signal.

I then can give different Fc for a fixed Fs=125khz or 31.25khz of 500khz.

This is the way i checked the response.