Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Error & CONF DONE LED both glow when programming cyclone III fpga

Hi, I m using Cyclone III EP3C120F780C7N FPGA in my project. While programming FPGA using .sof file, Error LED glows for a moment & then after some time CONF DONE LED glows. But when i see ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Whenever you program your device, all outputs are floating thus all LEDs are "half on" (no matter if you drive oder sink with output pin in the design later on). Also applies to the time, the FPGA need to download it's data from a configuration device. At least that is what happens on my development boards with Cyclone II and III FPGAs that have LEDs connected.