Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Design Being Removed

Hi, When I synthesize my design solely, the report is fine. But when I put it in an SOPC built design, only the top module which has only two pins (clock and a key) is left after synthesis. To ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
17 years ago

Thanks for the info. Actually, you're right, I changed the message level to 3 and now see the removal messages. So, now my question is, is there a way to ask the synthesizer not to remove them?! The reason I need this is because even if I send out some data lines as PINs, still some parts are being removed which shouldn't. Thanks again,

Kaveh