Forum Discussion
ASidd16
New Contributor
New ContributorSPI Mode
Hello Everyone.
I want to know how can i change SPI mode in NIOS software.
For example i have two chips, one chip has SPI mode 3 and the other has 1,
i want to use only one block in Qsys wit...
SyafieqS
Super Contributor
Super ContributorHi Ali,
It is always recommended for you to start with sample design. You can find very good references about how to use SPI communication, here is a good example of how to use SPI slave to AVALON memory mapped.
Thanks,
Regards
ASidd16New Contributor
New ContributorThank you for your help.
but this is not the answer of my Question.
SPI is working properly. I want to change SPI mode using NIOS.
Thank you
