Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Rs232 Uart Nios

Hello, I am trying to get hyperterminal or Putty to show either the boot messages or the stdout of my NIOS II program. I have tried configuring my HAL to output stdout to uart_0 (instead of jtag_...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

You mean in the BSP Editor where you configure the HAL right? Because I already did that. Still nothing...no evidence that anything is actually going through to the serial port.

Any other clues?

It's as if my serial port is not connected - which it is. But it would be the same effect if it were not.