Forum Discussion

GSite's avatar
GSite
Icon for New Contributor rankNew Contributor
7 years ago

Fail to generate a boot loader with QSPI Flash

I tried a lot of ways to download uboot to QSPI FLASH through the directive of quartus_hps. However, there will be errors. Error:Not able to halt CPU 0 Error:Fail to write 1 of DWORD(s) to address ...
gbuskirk's avatar
gbuskirk
Icon for New Contributor rankNew Contributor
4 years ago

Were you able to make any progress on this? I'm getting the very same responses, trying to load U-Boot to a QSPI device with quartus_hps. The FPGA has configured properly from it's own QSPI device. The HPS has its QSPI device where U-Boot should load from. I have confirmed BSEL is pulled up and down to BSEL[2:0] = 0x6 (1.8V QSPI).