Forum Discussion

GSite's avatar
GSite
Icon for New Contributor rankNew Contributor
7 years ago

Fail to generate a boot loader with QSPI Flash

I tried a lot of ways to download uboot to QSPI FLASH through the directive of quartus_hps. However, there will be errors. Error:Not able to halt CPU 0 Error:Fail to write 1 of DWORD(s) to address ...
GSite's avatar
GSite
Icon for New Contributor rankNew Contributor
7 years ago

​Thanks for your reply,I have learned the tutorial refer to https://rocketboards.org/foswiki/Documentation/A10Gsrd170QspiBoot

but I did not solve this problem.I designed a board using ARRIA10 SOC.When I download uboot to QSPI FLASH,The error information is shown in the figure1.Then I debug bootloader using ARM DS-5.The error information is shown in the figure2. What should I do?