Hello frankbarone,
1)
is there any documentation or training about how to provide user control refresh to dram through emif in agilex?i checked agilex emif user guide and did not find any steps on how to to do this.
- We don't have such documentation that you're looking for.
- Usually every dram has a datasheet and you can refer to refresh command for the memory to perform the refresh.
- You can refer to JEDEC website for dram command set. https://www.jedec.org/
2)
These these two parameters mutually exclusive? can i have both checked?
- Yes you should be able to enable both parameter.
New Contributor
