Forum Discussion

dsun01's avatar
dsun01
Icon for Contributor rankContributor
4 years ago
Solved

update DDR3 sdram uniphy to Arria 10

Dear Intel expert, I am learning how to use Platform Designer now, I have an EVM design from TI which was in Arria V. I need to upgrade it to Arria 10(SOC Dev Kit). there are few modules have to ...
sstrell's avatar
sstrell
Icon for Super Contributor rankSuper Contributor
4 years ago

Correct. Arria 10 EMIF architecture is completely different from Arria V. UniPHY is not used. Most of the interface is hardened in the I/O in A10.

  • dsun01's avatar
    dsun01
    Icon for Contributor rankContributor
    4 years ago

    Hi Sstrell

    Thank you very much for reply, I know there are lot of examples of the Arria 10 Dev Kit. is there any document/induction about how to update the Uniphy to an A10 interface. just delete the old one and create a new one? is there any special thing need pay attention.

    Best Regards,

    David