Forum Discussion

Vamsi_21's avatar
Vamsi_21
Icon for Occasional Contributor rankOccasional Contributor
3 years ago

System console giving up when running the command "TEST_PHYSERIAL_LOOPBACK 0 1G 1000"

Hi, I have generated the design example for Low latency ethernet 10g mac intel fpga ip-- 10M/100M/1G/10G example design(Arria 10) by following the below document. https://www.intel.com/content/www/...
Ethernet
ZiYing_Intel's avatar
ZiYing_Intel
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi Vamsi_21,


Could you try disable the NPDME option and try on hardware again?


Best regards,

zying


  • Vamsi_21's avatar
    Vamsi_21
    Icon for Occasional Contributor rankOccasional Contributor
    3 years ago

    Hi,
    I have disabled the NPDME option and tested on hardware, it is still showing the error below:
    “error: master_write_32: This transaction did not complete in 60 seconds. System console is giving up.


    While executing
    “master_write_32 sport_id $address $wdata”
    (procedure “reg_write” line 7)
    invoked from within
    “reg_write $PHY_IP_BASE_ADDR $seq_control 0X111”
    (procedure “SETPHY_SPEED_1G” line
    invoked from within
    “CONFIG_IPORT $speed_test”
    (procedure “TEST_PHYSERIAL_LOOPBACK” line 10)
    invoked from within
    TEST_PHYSERIAL_LOOPBACK 0 1G 1000”.