Forum Discussion
Contributorsimulate PCIe in Pipe mode
Dear Intel Support/Expert,
I have some problems while simulate AN829 in PIPE mode. I am using Quartus 21.3, PCIe Gen3 8 line. I can run in serial mode, but failed to run in PIPE mode.
1. question.
I noticed that at this link
Design Example - PHY Interface for PCI Express (PIPE) - Intel Communities
it claimed that the PIPE only supports Gen1 and Gen2. is this true in the latest Quartus 21.3. if true, then ignore this post. if not please have a look at the attached file. it has detail description of the problem I have.
thank you,
David
Hi David,
Yes, the example design only support Gen1 and Gen2.
I will proceed to close this case as per mention.
Regards,
Wei Chuan
2 Replies
Wincent_AlteraRegular Contributor
Hi David,
Yes, the example design only support Gen1 and Gen2.
I will proceed to close this case as per mention.
Regards,
Wei Chuan
- Wincent_Altera
Hi
As your question been addressed.
Hence, This thread will be transitioned to community support.
If you have a new question, feel free to open a new thread to get support from Intel experts.
Otherwise, the community users will continue to help you on this thread. Thank you
If you feel your support experience was less than a 9 or 10,
please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.
Regards,
Wincent_Intel
