Forum Discussion

pragathi_venkatesh's avatar
pragathi_venkatesh
Icon for New Contributor rankNew Contributor
1 year ago

SigTest 6.1.06 CLI TIE Error Message Unclear

Hi all, I'm running into an error where my test runs successfully when using the GUI but not the CLI. I ran the following in powershell: PS C:\Program Files\SigTest 6.1.06> .\SigTest.exe PCIe 6_...
Pcie
pragathi_venkatesh's avatar
pragathi_venkatesh
Icon for New Contributor rankNew Contributor
1 year ago

Right now, we use a Keysight BERT (or equivalent pattern generator) to send the 52UI PCIe6 jitter compliance pattern.

Wincent_Altera's avatar
Wincent_Altera
Icon for Regular Contributor rankRegular Contributor
1 year ago

Hi ,


May I know which device that you are using to run the test ? Agilex 7 device ? R-tile or P-tile ?
Above question is important for me in other to define an accurate answer towards your issue.
As far as I know Altera is not yet launching gen6 solution at the moment.

we use a Keysight BERT (or equivalent pattern generator) to send the 52UI PCIe6 jitter compliance pattern.
>> It seen to me like there is not related to Altera product, do you trying to reach out to Keysight support ?

Regards,
Wincent_Altera