Reading/Writing EPCS (MT25QU01G) with IP

Sounds good, thank you for answering my questions.

For future readers using cyclone 10GX with MICON MT25QU01G:

1) You can reliably use "ASMII Parallel Intel FPGA IP" for single read writes (and use a slow, less than 20 Mhz clock).

2) Use the "Generic Serial Flash Interface IP" if you would like to use a faster clock OR perform page writes.

3) Ensure that bytes being written from the hexout data to the micron/epcs be byte reversed. Use https://en.wikipedia.org/wiki/Intel_HEX#Record_types for how to understand the record types.

Best Regards.