Forum Discussion

RHobb's avatar
RHobb
Icon for Occasional Contributor rankOccasional Contributor
2 years ago
Solved

No User Manual for Terasic D8M-FMC (NDA) ?

I'm interfacing a Terasic D8M-FMC to a Stratix 10 Dev Board, and the problem is none of the register definitions listed in Chapter 6 of the OV8865 Rev 1D manual that Terasic supplied with the CD pack...
Video
  • RHobb's avatar
    RHobb
    2 years ago

    So apprently, Omnivision reached out to me after I wrote them to obtain a datasheet on there website, which has a link attached to write them directly to obtain a NDA. According to Omnivision, I need to be company or corporation and must order several of there sensors, and they can provide both engineering support, in addition to providing an NDA for there sensor datasheet. The Rev. 1D datasheet is merely a pamphlet to barely even get the sensor running. There are more than 50 registers not documented in this.

    The reasoning is simple, it's there to protect the company and there IP from nefarious reasons. It doesn't make any sense to me, the end user owns the product, but yet they can keep information from you using the product to it's full potential.

    I saw nothing in the marketing material on Terasic website that they had a NDA with Omvision and I would not be given the complete register map for this product. Terasic does have this datasheet but for obvious reasons cannot disclose it.

    Apparently this is now a trend, and more companies are doing the same practices.

RHobb's avatar
RHobb
Icon for Occasional Contributor rankOccasional Contributor
2 years ago

So apprently, Omnivision reached out to me after I wrote them to obtain a datasheet on there website, which has a link attached to write them directly to obtain a NDA. According to Omnivision, I need to be company or corporation and must order several of there sensors, and they can provide both engineering support, in addition to providing an NDA for there sensor datasheet. The Rev. 1D datasheet is merely a pamphlet to barely even get the sensor running. There are more than 50 registers not documented in this.

The reasoning is simple, it's there to protect the company and there IP from nefarious reasons. It doesn't make any sense to me, the end user owns the product, but yet they can keep information from you using the product to it's full potential.

I saw nothing in the marketing material on Terasic website that they had a NDA with Omvision and I would not be given the complete register map for this product. Terasic does have this datasheet but for obvious reasons cannot disclose it.

Apparently this is now a trend, and more companies are doing the same practices.