Forum Discussion
akaanb
New Contributor
New ContributorFailing to run on hardware Nios II
Hi, I am trying to create a memory test program for an old mass produced product. The FPGA is Cyclone IV EP4CGX50. I am trying to use ALTMEMPHY IP because this is what was used in the product and ...
ShengN_altera
Super Contributor
Super ContributorHi,
May be can refer to this document 5.2.5.1. Nios® II Processor Application Executes in-place from OCRAM:
Also, make sure the reset has proper connection.
Thanks,
Best regards,
Sheng
p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.
