ymiler
Contributor
ContributorECO issue
Hi,
I try to change the LUT output value by the command " modify_lutmask "
The TCL file includes the content : modify_lutmask -to eco_sig_1_cZ~0 -mask 0x1
But I get errors when I begin the pe...
Forum Discussion
Nurina
Regular Contributor
Regular ContributorHello,
The DATAF is at the bottom left of the picture you shared.
Again, you can try to add connection here.
Regards,
Nurina
ymilerContributor
ContributorHi Nurina
2 questions
1) Why should I configure DATAF since this port doesn't use ( gray color ) ?
2) why the command : "mask 0x00000000FFFFFFFF" ( F3 & F2 = 0 , F1 & F0 = F ) get error for DATAF
and ( F3 & F2 = F , F1 & F0 = F ) get no errors - why is it relevant to DATAF ? Its only relevant to the F3/F2/F1/F0 masks ?
Yishay
