Does the Multi-Rate Ethernet PHY Intel® FPGA IP supports MGBASE-T for Cyclone 10 GX?

Question

We managed to implement the Multi-Rate PHY on a Cyclone 10-GX with 10GBASE-R protocol but it seems that it does not accept 1000BASE-X  protocol.
From documentation this is only possible when using the MGBASE-T mode , however we can not instantiated this mode in the IP core configuration (greyed out), we only could instantiated USXGMII.
 
Can someone advise?

deshi_intel · Accepted Answer

Hi,You can find multirate PHY IP user guide in below doc link (chapter 2)https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/ug_cyclone10_xcvr_phy.pdfI can see that in page 100, table 104 - it's clearly stated that C10 GX device doesn't support  MGBASE-T PHY.So, I hope I clear your doubtThanks.Regards,dlim

Forum Discussion

Does the Multi-Rate Ethernet PHY Intel® FPGA IP supports MGBASE-T for Cyclone 10 GX?

1 Reply

Recent Discussions

Agilex 7 slew rate reconfiguration

Agilex-7 AXI MCDMA for PCIe hang

Constraints not being picked for DCFIFO

Can't generate F-Tile Ethernet Hard IP Design Example

MAX10 TSE reference design