Forum Discussion
Michael2021
Occasional Contributor
Occasional ContributorCyclone 10 GX DisplayPort Rx
Hello dlim,
I modified the custom Dipalyport Receiver board. The Modified point is CLKUSR pin only
DisplayPort Receiver function still doesn't work.
I attached two picture.
Picture 1 : cy...
Deshi_Intel
Regular Contributor
Regular ContributorHi,
Are you using very old Quartus version ?
- I do a quick check on v20.4 Quartus Pro and I can see that C10 GX FPGA DP IP did support till 8.1G.
The other thing to take note is for 8.1G (HBR3) support, it recommended to use repeater/retimer for DP Rx side. Checkout below link page 8, table 8
Thanks.
Regards,
dlim
