Forum Discussion

New Contributor

3 years ago

Bus error during booting into FPGA Hardware

We use "10AS048E3F29I2SG" (Arria 10) device. While booting the fpga hardware, in serial prints following bus error is coming Fail: noc_idleack = 0x01110111 mask_noc = 0x00100111 Kernel imag...

Jeet14

Frequent Contributor

3 years ago

Hi Swetha,

Are you using the GHRD and GSRD? If yes then which version?
Are you creating custom quartus & Qsys project? If yes then, what are the steps you had followed for building uboot? Latest uboot building procedure is given on https://www.rocketboards.org/foswiki/Documentation/BuildingBootloaderCycloneVAndArria10

Regards

Tiwari

Forum Discussion

Bus error during booting into FPGA Hardware

Recent Discussions

Constraints not being picked for DCFIFO

Cyclone 10 GX IBIS-AMI models

F-Tile Ethernet Hard IP (100G)

Cyclone® 10 GX Avalon®-ST Interface for PCI Express example Simulation

Agilex-7 AXI MCDMA for PCIe hang