10G Ethernet IP on Cyclone 10 GX with IEEE 1588 support - Ordering Guide

Hi,

For the PHY, the IP to be purchased seams to be IP-10GMRPHY. Is it correct?

Yes, you're correct.

For the MAC:

Question 1: Do I need to purchase both IP-10GEUMAC and IP-10GEUMACF or is IP-10GEUMAC integrated into IP-10GEUMACF license?

For Cyclone 10 GX, you just need IP-10GEUMAC. IP-10GEUMACF is for F-Tile Low Latency Ethernet 10G MAC Intel® FPGA IP for the Agilex™ 7 (F-Tile) devices

Question 2: When I compile my design in evaluation mode I get "Evaluation Mode" messages for 3 IPs:

IP-10GMRPHY - 10Gb Ethernet PHY Intel® FPGA IP

IP-10GETHMACF - F-Tile Low Latency Ethernet 10G MAC Intel® FPGA IP

Low Latency Ethernet 10G MAC - Low Latency Ethernet 10G MAC Intel® FPGA IP

Thanks,

Regards,

Sheng

Hi,

I don't understand your answer related to the F-Tile for Agilex. I'm compiling the MAC with IEEE 1588 for Cyclone 10 and I get a licensing message concerning the IP-10GETHMACF, so it's mandatory for this feature on Cyclone 10?

Regards,

Christophe