Forum Discussion

JMiret's avatar
JMiret
Icon for New Contributor rankNew Contributor
4 years ago
Solved

100G Ethernet IP (Stratix 10) does not complete placement

Hi, We're attempting to route a 100G interface with RS-FEC, using the Low Latency 100G IP. When we configure the IP without RS-FEC, it routes, but when we enable RS-FEC, it consistently fails to s...
  • RichardT_altera's avatar
    RichardT_altera
    4 years ago

    Hi @JMiret

    Yup, it seems to be the case. In fact, I would recommend users to use the latest Quartus version 21.2 as we have fixed quite a few errors in the latest Quartus release.

    With that, I believe your current issue has been resolved. Do you need further help in regards to this case?

    Best Regards,
    Richard Tan

    p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.

JMiret's avatar
JMiret
Icon for New Contributor rankNew Contributor
4 years ago

Hi,

When running the identical design in Quartus 19 or 20, we would get the above errors - however, when using Quartus 21.2, we not seen any instance of these errors. Based on this, it looks like it was an error related to those versions of Quartus.

RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
4 years ago

Hi @JMiret

Yup, it seems to be the case. In fact, I would recommend users to use the latest Quartus version 21.2 as we have fixed quite a few errors in the latest Quartus release.

With that, I believe your current issue has been resolved. Do you need further help in regards to this case?

Best Regards,
Richard Tan

p/s: If any answer from the community or Intel support are helpful, please feel free to give Kudos.