who can tell me how to get the Vision of Max II of your FPGA?

Question

"Before you use the Cyclone III FPGA Development Board for the first time, you need to make sure that it is updated with version 1338 or higher of the Max II Design."

altera_forum · Answer

there are some instructions at the bottom of the kit page, in the errata section  http://www.altera.com/products/devkits/altera/kit-cyc3.html

altera_forum · Answer

much appreciate&amp;#65292;thanks guy&amp;#65281;&amp;#65281;

Forum Discussion

who can tell me how to get the Vision of Max II of your FPGA?

2 Replies

Recent Discussions

DE1-SoC project compiles, but board programming fails 42% through

Compatibility and Configuration of Arria10 Devices with and without HPS

USB Blaster conflicts with other FTDI devices result in PC crash

MAX10 Single end I/O low/high speed bank frequency

Device migration about DD and DA