Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

which altera board should i use in my robotic project

Hi I have a robotic project in which i have to controlle 3 powerful steppers motor ,keyboard, VGA, and 40 leds . I did work with altera de1 board only when i was in school, i don't know about t...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

Look at chapter 4 of the DE1 board's user manual. If you don't have it you can download the manual from here: de1 user manual (http://www.terasic.com.tw/cgi-bin/page/archive_download.pl?language=english&no=83&fid=91d2cf46f90973377b1f71bd42040740)

It discusses putting the FPGA's configuration image into an EEPROM using Active Serial (AS) mode. Once done your board will automatically load the FPGA, from the EEPROM, when the board is powered up.

Regards,

Alex