Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Weird Problem with configuring CycloneIII

Hi everybody, I hope somebody can help me in my problem: I configured my board with EP3C25E144 Cyclone. Programmer stop working because it indicate different code: expected 020F0DD and it foun...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
9 years ago

Thanks for reply,

Yes, I bought them (two chips) on Aliexpress. I have to say, I did it a few times and all was fine. But now probably is like in your suspicious.

I soldered two boards with chips from this seller. In meantime I tried configured second one.... and same effect.

Well, thanks a lot for your reply. Nothing in web didn't match my problem, and after your question I'm sure I have to buy two new chips and solder them again.

Maybe they are ep3c10.... with engraved signs. Strange, because in my opinion to do it well you have to have nice tools. At least I'm sure my board are OK.

Thanks again for looking on my post.

Tomasz