Forum Discussion
PDone
Occasional Contributor
Occasional ContributorVerifying that a Cyclone V FPGA is good
I have a cyclone V FPGA Image which no longer runs in my board . This image ran in my board and is still running on other boards. If I reload an earlier image it works fine. There is no change to ...
jrrguzmanOccasional Contributor
Occasional Contributor@PDone The fact that sometimes works (it worked before but not now) or works at other boards but not in this one seems like a timing issue...but I can't tell with just the description you provide.
Try changing the seed for the fitter so the design placement changes as well and you might get a "working design" again.
