Unable to program Remote System Upgrade over UART based on NiosII Processor with EPCQ(cyclonev dev )

Question

unable to program:Remote System Upgrade over UART based on NiosII Processor with EPCQ (Cyclone V E FPGADevelopment Kit) design example to CycloneV E FPGA Dev kit.shown errors while programming files through Quartus prime programmer: Can't recognize silicon id for device1. A device's silicon ID is different from its JTAG ID: VERIFY THAT ALL CABLES ARE SECURELY CONNECTED

farabi · Answer

Hello,

Can you refer to this reference design?

link : https://www.intel.com/content/dam/support/us/en/programmable/support-resources/fpga-wiki/asset03/nios-ii-processor-booting-from-cfi-flash.pdf

regards,

Farabi

farabi · Answer

Hello, Please also refer to this link : https://www.intel.com/content/www/us/en/support/programmable/support-resources/design-examples/horizontal/system-upgrade-over-uart-nios-ii.htmlregards,Farabi

farabi · Answer

Hello, I have provided you the answer, I will transfer this case to community. If you have another question, please raise new forum case we will be happy to help. regards,Farabi

Forum Discussion

Unable to program Remote System Upgrade over UART based on NiosII Processor with EPCQ(cyclonev dev )

3 Replies

Recent Discussions

Avalon-ST configuration with Agilex 3 fails

Cyclone IV E – PLL Power Track Width Recommendation Clarification

JTAG Chain Broken on Agilex 7-I Dev Kit

Question

Quartus Prime Pro 25.1 fatal error during fitter: Windows "Efficiency mode" required