Forum Discussion

Rezak3021's avatar
Rezak3021
Icon for New Contributor rankNew Contributor
2 years ago

TSE RGMII data send using Avalon problem

Hello everyone. I'm new to Intel FPGAs.

I have a problem. I adde Triple-speed ethernet IP and I want to test if it works or not. My phy is a 1512 Marvell. so I use RGMII. I wrote the config_eth to configure MAC and PHY. I also write pack_gen to send data to PC. But when I check wireshark, my packet is not there. Can you guide me to find my mistakes please?

Thanks

Configuration

3 Replies

  • ZiYing_Intel's avatar
    ZiYing_Intel
    Icon for Frequent Contributor rankFrequent Contributor
    2 years ago

    Hi,


    May I know you are using which Quartus version and OPN?


    Best regards,

    zying


  • ZiYing_Intel's avatar
    ZiYing_Intel
    Icon for Frequent Contributor rankFrequent Contributor
    2 years ago

    Hi,


    Besides that, can you share the detail information about the phy that you used through the link?


    Best regards,

    zying


  • ZiYing_Intel's avatar
    ZiYing_Intel
    Icon for Frequent Contributor rankFrequent Contributor
    2 years ago

    Hi,


    Since no hear any feedback from you, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread.


    Best regards,

    zying