Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

To read data from cyclone III

Hi all

I am using cyclone III development kit. I want to read data from FPGA. I sent signal to ADC. The output data of ADC was sent FPGA processor. My FPGA has only jtag configuration input. How I read data from FPGA?

2 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    15 years ago

    Hello everyone!

    Can anyone help me? I need to connect a cyclone II (DE2 Board) FPGA with FlexRay-Nodes. As far as I know, I need a transceiver in order to connect the Nodes to FPGA. Has someone got experience with this? One node has to communicate with my FPGA via SPI connection and the others have to communicate with FPGA via a serial bus. The FPGA has to act as Gateway between the FlexRay-Nodes in order to transmit messages from one end to the other. The SPI connection has to send FPGA some controll signals, to tell FPGA if it has to transmit messages or not. Has anyone done such like tasks? Is there maybe any IP-Core that I can use to build my project. PLEASE HELP!

    Thank you everyone for your assistance!