Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

timescale related query ..

Can anyone explain why the simulator shows the following output for the below verilog code : Output : run # 0x Thanks a ton in advance! -----------------------...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Thanks Jake for the reply.

But then in the second case when I have set timescale as 1ns/1ns , then since I have set the time-step as 1ns , issuing "run" once should have then shown the simulation results uptil 1 ns only, right ? But when I try this on Modelsim ( ie issue "run" once ) , it shows the complete simulation data ...ie upto 31 ns.

Please correct me if am wrong somewhere.

Many Thanks.