Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

System ID issue

Hi everyone,

I am working in a project using Quartus v11.0. The Bsp was created using Qsys.

*obs: The project was updated/converted from SOPC Builder to Qsys...

So, I am having problems to load the application into the FPGA. Attached is the problem that I have. No System ID found and timestamp.

I have a feeling that the problem is based on my BSP file. Because, the flash programmer cant see the System ID (probally NOT a software issue...so).

Did anyone had this experience before?? What all I need to have in Qsys to set he system ID??

Thank You very much

12 Replies

Show More
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    Yes I do have a system ID component, and I did upload the image (.sof).

    Is there anything else I might be missing?

    Thank You
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    Do you have the system ID component in the QSys project? Did you upload the image in the FPGA before using the Nios programmer?