Stratix V FPGA Ordering Part Number and Release status

Question

I'm interested in the usage of the Stratix V FPGA mentioned on this page:

FPGA for Military Applications - Intel® FPGA

And while the section for the Stratix V FPGA says it should be available in 2015, I don't see the page having been updated with any part numbers I can inquire further about or order.

What is the current release status of the Stratix V FPGA?

nazrulnaim_intel · Answer

Hello,I'm truly sorry for the delay. For more information regarding the device that you have mentioned above. I will provide the link where you can check the Ordering and Compliance for the device.Link : Stratix V 5SGSD5 FPGA Product Specifications (intel.com)Hope this helps.Best regards,Nazrul Naim

shad3 · Answer

Thank you for the response.

I was also interested in the Cyclone series of FPGA boards you are offering.

Do you have a -55°C minimum junction temperature rated version of your Cyclone FPGAs, similar to how your Stratix products are rated for -55°C?

Or would it be possible to have a version of the Cyclone FPGA developed that does offer -55°C?

Thank you for your time.

nazrulnaim_intel · Answer

Hello,For your information Cyclone device only have the minimum of junction temperature of -40°. For more information regarding Cyclone device, it can be accessed through the link below.Cyclone IV : https://cdrdv2.intel.com/v1/dl/getContent/653974?explicitVersion=true&amp;fileName=cyclone4-handbook.pdf Cyclone V : https://cdrdv2.intel.com/v1/dl/getContent/666729?fileName=cv_51001-683694-666729.pdfCyclone 10 : https://cdrdv2.intel.com/v1/dl/getContent/666875?fileName=c10lp-51001-683879-666875.pdfHope that answers your question.Best regards,Nazrul Naim

shad3 · Answer

Do you happen to have another FPGA option that fits the Cyclone Footprint, but is rated for -55°?

I'm looking for something to use in a design that will be able to replace the Cyclone V in in footprint and functionality, but I'm needing it to be rated at -55° for the minimum junction temperature.

nazrulnaim_intel · Answer

Hello,For your information there is no direct drop in replacement regarding the foot print for Cyclone V that have the junction temperature of -55. The device that has the junction temperature of -55 degrees is Arria 10 GX. Below I will attach the link for the device overview of Arria 10 GX.Link : https://cdrdv2.intel.com/v1/dl/getContent/670810?fileName=a10_overview-683332-670810.pdfHope that answers your question.Best regards,Nazrul Naim

Forum Discussion

Stratix V FPGA Ordering Part Number and Release status

7 Replies

Recent Discussions

B32A (1591) Package Mechanical Drawing

JTAG Chain Broken on Agilex 7-I Dev Kit

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration