SOPC/Quartus II "pass through component" problem

Hi jakobjones,

My problem right now is the following;

I have my components connected in SOPC but obviously my pass through component is not doing anything. And I don't know how to make it pass the CVI signal onto the CVO :(

Basically when I get back to Quartus, compile it and then upload it to the FPGA using Programmer, nothing is happening because it is not passing through the signals.

If I had one example code that shows the communication from clocked video input to something else or to clocked video output that would b e very useful.

Right now, I am stuck and I don't know where to start and how to start writing Verilog.

And as you can guess, I am a newbie ...

Hope you can give me a kick start,

Tyler