Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributorsolution for mcu to configure ALTERA FPGA
Hello, i'm trying to use a MCU(like C8051) to configure Cyclone IV device(EP4CE30) in Passive Serial mode. In the past, i was using GPIO of MCU to simulate the configure timing. But configure sp...
Altera_ForumHonored Contributor
Honored ContributorThe example for RSU in the wiki below is based on EPCS chip from Altera. But, in my system, a SPI flash from Micron (M25P80) is used. Is there any problem to use this example in my system?
http://www.alterawiki.com/wiki/epcs_...mote%20upgrade
