Regarding Configuration Memory part# EPCQ16ASI8N and Cyclone III part# EP3C25F256C8N

Question

Hi,
We have legacy board in which we have used FPGA Config. memory part no. EPCS16SI8N which is Obsolete. Alternate we found is EPCQ16ASI8N for proto development however as per MOUSER it has Life cycle issue. Can you please confirm EOL of  same part i.e. EPCQ16ASI8N
Also can you please confirm EOL of CYCLONE III FPGA part no. EP3C25F256C8N ?

https://www.mouser.com/ProductDetail/Intel-Altera/EPCQ16ASI8N?qs=sGAEpiMZZMv0NwlthflBi1lM0BLNIdmn%2F%2Fk%252BJ9EHhHw%3D

https://www.mouser.com/ProductDetail/Intel-Altera/EP3C25F256C8N?qs=sGAEpiMZZMv0fKVy8cA0Dbm1GNlLHTbIbsc6p38EulA%3D

Please reply at earliest

Regards,
Puspam Nayak
Mysore, India

yuanli_s_intel · Answer

Hi, EP3C25F256C8N is still active but not recommended for new design.

EPCQ16ASI8N is also still active. Alternatively, you can use EPCQA as a replacement for them.

https://www.intel.cn/content/www/cn/zh/programmable/documentation/tfb14981073813581.html

Forum Discussion

Regarding Configuration Memory part# EPCQ16ASI8N and Cyclone III part# EP3C25F256C8N

1 Reply

Recent Discussions

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information