Forum Discussion

Yassine-Ca's avatar
Yassine-Ca
Icon for New Contributor rankNew Contributor
1 year ago

Read from memory

Hello, I'm working on DE1-SoC Cyclone V FPGA. I have prgrammed the FPGA to store a static data to the onchip memory created on Platform Designer, this generated the definitio...
Configuration
RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
1 year ago

Hi,


Do you need any further assistance from my side?


Regards,

Richard Tan



  • Yassine-Ca's avatar
    Yassine-Ca
    Icon for New Contributor rankNew Contributor
    1 year ago

    Hello,

    I tried many time using System console with the following commands:
    %get_service_paths master
    /devices/5CSE(BA5|MA5)|5CSTFD5D5|..@2#USB-1#DE-SoC/(link)/JTAG/alt_sld_fab_sldfabric.node_0/phy_0/jtag_master.master

    % open_service master "/devices/5CSE(BA5|MA5)|5CSTFD5D5|..@2#USB-1#DE-SoC/(link)/JTAG/alt_sld_fab_sldfabric.node_0/phy_0/jtag_master.master"

    % is_service_open master "/devices/5CSE(BA5|MA5)|5CSTFD5D5|..@2#USB-1#DE-SoC/(link)/JTAG/alt_sld_fab_sldfabric.node_0/phy_0/jtag_master.master"
    1

    % master_read_memory "/devices/5CSE(BA5|MA5)|5CSTFD5D5|..@2#USB-1#DE-SoC/(link)/JTAG/alt_sld_fab_sldfabric.node_0/phy_0/jtag_master.master" 0x00000000 8

    When I writed the last comman system console displays the same issue even I try to follow the link instructions.

    Regards.

    • Yassine-Ca's avatar
      Yassine-Ca
      Icon for New Contributor rankNew Contributor
      1 year ago

      Hi,

      Thank you, I used Eclipse with NIOS II and it is working.

      I need now to send the program into flash memory, In platform Designer I choose Generic QUAD SPI Controller II, but I don't know which configuration device type do I need to choose, I have DE1-SoC Cyclone V FPGA. The memory i'll use is 32 GB.

      Regards.