Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Rbf jic issue

Hi, I am working with a cyclone IV device EP4CE55 in a project. I programmed jic and the fpga is configuring properly. I programmed rbf file of the same project,FPGA is not configuring.I can s...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
8 years ago

Hi,

1. Have to set msel to Passive serial mode?

2. Check the pull-up resistor.

Try to regenerate the .rbf file.

Refer previous threads

https://www.alteraforum.com/forum/showthread.php?t=44219

https://alteraforum.com/forum/showthread.php?t=6499

Steps:

1. Open Convert Programming File tab.

2. Choose Programming file type - JIC

3. Choose all needed settings

4. Check the Create config data RPD

5. Press Generate.

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)