Forum Discussion

yong's avatar
yong
Icon for Occasional Contributor rankOccasional Contributor
4 years ago

Quartus Programmer fails to auto detect device on Cyclone10 GX Dev kit

Hello, I am testing ASx4 configuration on Cyclone10 GX Dev kit. I use Quartus Programmer tool to download .jic file to flash. In Quartus: Tool -> Programmer GUI, when I click auto detect, it cannot...
JohnT_Altera's avatar
JohnT_Altera
Icon for Regular Contributor rankRegular Contributor
4 years ago

Hi,


May I know both is connected to the same JTAG port? May I know if you are able to share with me your board schematic?


  • yong's avatar
    yong
    Icon for Occasional Contributor rankOccasional Contributor
    4 years ago

    Thanks John for looking into this!

    I believe both is connected to the same JTAG port. I am working on the Cyclone10 GX development kit purchased from Intel website. I only replaced QSPI configuration flash on the board, nothing else changed. Attached is the schematic for the Cyclone10 GX development kit I downloaded from Intel website.

    Actually it was working well before I executed an erase operation from Quartus Programmer. I am not sure if I accidentally erased the factory default build in MAX10 (or the CFI flashes connected to MAX10).

    Thanks!