Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Programming NIOS II code to EPCQ in Quartus 13.1

Hello I'm having trouble with NIOS II code executing from an EPCQ x4 flash chip (p/n Micron N25Q256A) after a power cycle. I've followed the following guideleins to boot from EPCQ or EPCS (fro...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
12 years ago

Sorry Alex, I only partially answered your questions.

- I am converting the SOF to a JIC and using JTAG to program the EPCQ (it's a 256 Mbit Micron Serial NOR flash).

- The board is an SoCKit development kit from Arrow. The FPGA P/N is a Cyclone V SoC, 5CSXFC6D6F31C8NES.

- The FPGA seems to configure, but the NIOS code never runs.